AZ82.60-P-0001-01SC Retrofit iPod Interface Wiring Harness

AZ82.60-P-0001-01SC Retrofit iPod Interface Wiring Harness
- except CODE (498) Japan version
- with CODE (386) Preinstallation for telephone "Handy", UPCI system
- with CODE (388) Telephone "Handy", UPCI system

Component Identification:

Risk of breakage: Do not kink fiber optic cable, route over sharp edges or bend in radii smaller than 25 mm. Tensile forces on inserts must not exceed 65 N. Do not squeeze fiber optic cable and do not compress with clamps or cable ties.

1 If present, remove MOST coupling (13) from standard COMAND coupling (14).

Shown on model 221







2 If present, install MOST coupling (13) in COMAND adapter coupling (12) of interface wiring harness (10).
3 Connect standard COMAND coupling (14) to COMAND adapter connector (11) of interface wiring harness (10).
4 Wrap COMAND adapter connector (11) in self-adhesive felt.

The COMAND adapter coupling (12) of the interface wiring harness (10) is connected to the COMAND control unit later.

5 Route interface coupling (9) of interface wiring harness (10) from COMAND installation opening behind right side piece (19) of center console in vicinity of glove box as per picture (see enlarged detail).

Interface coupling (9) of interface wiring harness (10) will be connected to iPod interface at a later point in time.