Procedures

AR33.10-P-0100-06CW Detach, connect front axle multiple circuit junction connector

Component Identification:

Shown on model 204 with steel suspension
1 Press spring detent (3) on front axle electrical distributor downwards and
^ pull connector for left front axle rpm sensor and right front axle rpm sensor, (L6/1, L6/2)
^ Connector for brake wear sensor at right front (S10/2)

out of the front axle electrical distributor.

2 Unclip electrical feed lines (1) from line holders (2) and place to one side.

The connector for the brake wear sensor is only fitted to the front axle distributor on the right-hand side of the vehicle.

Model 212 with code (489) AIRMATIC (air suspension with continuous damper adjustment) or code (488) Steel/air suspension and model 207 with code (483) ADVANCED AGILITY package: The lines for the right front brake wear sensor (S10/2) and the right front axle damping valve unit (Y52) are combined to form a single line on the right. The left front axle damping valve unit line (Y51) is plugged onto the left front axle electrical distributor connector.