AZ82.60-P-0001-02EW Retrofit iPod Wiring Harness

AZ82.60-P-0001-02EW Retrofit iPod Wiring Harness
- with CODE (523) MB Audio 20 radio
- with CODE (510) Audio 20 with CD changer
- with CODE (525) MB Audio 50 APS radio

Component Identification:

1 Finish cutout on insulation mat (11) on left on glove compartment (10).

Dimensions:
a = 40 mm
b = 35 mm
c = 30 mm

2 Make a mark on left on glove compartment (10).

Dimensions:
d = 30 mm
e = 100 mm

3 Drill bore (arrow A) with a diameter of 19 mm corresponding to the mark made beforehand on the left at glove compartment (10).
Cordless drill/driver
gotis://G_58.0_01.1

4 Open cover of glove compartment (10).
5 Route iPod wiring harness (8) in glove compartment (10) and route black iPod wiring harness coupling (7) of iPod wiring harness (8) to the outside through previously drilled hole.
6 Insert grommet (12) into hole.

7 Wrap iPod wiring harness (8) in felt tape (13), beginning at glove compartment (10).
8 Wrap iPod interface (6) with felt tape (14) as shown.

Leave a cutout free for adhesive strips (15) included in package contents.

9 Stick adhesive strips (15) included in package contents, as shown, onto iPod interface (6).

10 Remove fiber optic cable (16) from black 44-pin coupling (1) and install at same position in black 44-pin coupling (4).

Only if installed.

11 Connect black 44-pin connector (2) of iPod interface wiring harness (3) to black 44-pin coupling (1) of vehicle wiring harness.

The black, 44-pin coupling (4) is connected at a later stage.

12 Route black 18-pin coupling (5) of iPod interface wiring harness (3) to the right below the instrument panel.
13 Connect black 18-pin coupling of iPod interface wiring harness (3) to iPod interface (6).
14 Wrap iPod interface wiring harness (3) with felt tape.

15 Remove protective foil from adhesive strip at iPod interface (6) and glue iPod interface (6) to cable duct (17).
16 Fold floor covering (18) to one side and route iPod interface wiring harness (3) behind this.
17 Place glove compartment (10) in front passenger footwell.
18 Connect black iPod wiring harness coupling (7) of iPod wiring harness (8) at top (arrow B) to iPod interface (6).