AN82.60-P-0016-02ECA Retrofit Media Interface Wiring Harness

AN82.60-P-0016-02ECA Retrofit Media Interface Wiring Harness
- with CODE (527) COMAND APS with single DVD drive (with navigation)
- with CODE (512) COMAND APS with DVD changer


1 Carefully break cutout (1.1) out of glove box (1) along perforation.
2 Open lid of glove box (1).
3 Clip cover contained in package contents into opening (arrow A) in glove box (1).

AUX jack electrical connector was installed in the opening (arrow A).







4 Route media interface wiring harness (2) from inside through opening in glove box (1).
5 Clip media interface electrical connector (X18/70) into glove box (1).
6 Wrap felt tape around media interface wiring harness (2).







7 Connect coupling (5) of video signal adapter line (4) to video signal line (3).







8 Place glove box (1) into front passenger footwell and route video signal line (3) with video signal adapter line along broken line in slot of COMAND controller unit.
9 Connect black coupling (5) of media interface wiring harness (2) to free slot of media interface control unit (N125/1).










Only perform the following steps on vehicles with code (610) Night View Assist.

10 Open lock (7) of contact cavity 1 at green 1-pin housing (8) of video signal adapter line (4).
11 Remove coupling (6) of video signal adapter line (4) from contact cavity 1 of green 1-pin housing (8).

The green 1-pin housing (8) is no longer required.

12 Open lock (7) of contact cavity 1 at green 2-pin housing (9) of Night View Assist line (10).
13 Insert coupling (6) of video signal adapter line (4) in contact cavity 1 of green 2-pin housing (9) and engage lock (7).

The video signal adapter line (4) is connected to the COMAND controller unit at a later point.