AZ82.70-P-0001-04EW Retrofit Wiring Harness

AZ82.70-P-0001-04EW Retrofit Wiring Harness.
- except CODE (279) Electronic gear selector

Component Identification:

1 Unclip and remove cover (10) of black 18-pin connector (5) at iPhone wiring harness (4) and detach iPhone wiring harness (4) from plug insert (9).

Do not damage the individual pins, as otherwise it will be impossible to plug them into the plug insert (9) and a new iPhone wiring harness (4) will have to be installed.

Additionally mark transparent lines with adhesive tape and label according to their contact cavity assignment.

2 Wrap insulation tape around the ends of the lines (arrow A) of the iPhone wiring harness (4).

3 Drill hole (arrow B) with diameter of 9 mm, as shown, at center console (11).
Cordless drill/driver gotis://G_58.0_01.1

4 Guide iPhone wiring harness (4) with previously detached side through hole from inside.

Do not damage ends of line (arrow A).

5 Route iPhone wiring harness (4), as shown, at center console (11) and fix in place with felt tape.
6 Remove insulation tape from ends of line (arrow A).

7 Plug iPhone wiring harness (4) into plug insert (9).

Contact cavity assignment:
Contact cavity 1 Black
Contact cavity 2 Clear
Contact cavity 3 Yellow
Contact cavity 4 Blue
Contact cavity 5 Pink
Contact cavity 6 Orange
Contact cavities 7 to 9 Not assigned
Contact cavity 10 Gray
Contact cavity 11 Clear
Contact cavity 12 Brown
Contact cavity 13 Green
Contact cavity 14 White
Contact cavity 15 Clear
Contact cavities 16 to 18 Not assigned

Assign transparent lines to individual contact cavities according to previously made markings.

8 Slide cover (10) onto plug insert (9) and clip in.
9 Open lid of glove compartment.
10 Connect iPhone wiring harness (7) to media interface electrical connector (X18/70).
11 Route iPhone wiring harness (7), as shown, and fix in place with felt tape (area A).

Ensure that iPhone wiring harness (7) is not damaged by chafing, pinching or crushing, otherwise this must be replaced.

12 Repeatedly open and close lid of glove compartment to check its unobstructed movement.

Reposition iPhone wiring harness (7) if necessary.

13 Insert and position center console (11).

Pay attention to installation position of plugs and couplings at center console (11) so that electrical connections can be made later.

14 Make electrical connection between black 18-pin coupling (6) of iPhone wiring harness (7) and black 18-pin connector (5) of iPhone wiring harness (4).
15 Wrap black 18-pin connector (5) of iPhone wiring harness (4) with felt tape and route below floor covering (12).

16 Insert cradle (1) in Bluetooth module (A34/7) and connect black connector (2) of cradle (1) with black coupling (3) of iPhone wiring harness (4).