AR35.20-P-0116-01SX Remove/Install Supporting Joint on Wheel Carrier

AR35.20-P-0116-01SX Remove/install supporting joint on wheel carrier
- except CODE (Z07) Top protection

Special Tools:

Component Identification:

Remove supporting joint
1 Pull the supporting joint (7a) out of the wheel carrier (7) using the extraction and insertion tool.
2 Remove extraction and insertion tool with supporting joint (7a).

Component Identification:

Install supporting joint
3 Position extraction and insertion tool with supporting joint (7a) on wheel carrier (7).
4 Use the extraction and insertion tool to pull the supporting joint (7a) into the wheel carrier (7) against the direction of travel.

Pull in the supporting joint (7a) with the thrust piece part 01 (06a) until this abuts at the machined contact surface (arrow). The supporting joint (7a) is correctly pulled in when it is seated in the center of the wheel carrier eye (7b).