Transmission Position Sensor/Switch: Adjustments

Manual Lever Position (MLP) Switch

Tools Required:
- Gear Position Sensor Adjuster T92P-70010-CH

1. Raise and support the engine.

2. Remove the six splash shield bolts, splash shield screw and the LH inner splash shield.






3. Remove the shift cable nut and shift cable from the manual lever.






4. Place the MLP switch in the N position.

5. Loosen the three MLP switch bolts.

6. Insert Gear Position Sensor Adjuster T92P-70010-CH between the alignment holes in the MLP switch and the manual lever.






7. Tighten the three MLP switch bolts to 3 Nm (27 lb-in).

8. Position the shift cable on the manual lever and install the shift cable nut. Tighten the shift cable nut securely.

9. Position the LH inner splash shield on the vehicle and install the six splash shield bolts and splash shield screw.

10. Lower the vehicle.