E2 Check Wires Between Brake Control Module and Brake Sensors

- Key OFF.

- Disconnect the brake antilock sensor connectors.

- Connect the breakout box with adapter to the antilock brake control module connector. Leave the antilock brake control module disconnected.

- Measure the resistance of the following wires between the BOB Pins and the brake antilock sensor connectors.

Brake Antilock Wire Color BOB Pin
Sensor

RH W 16
Front Brake Antilock Sensor GN 56

LH Y/BL 9 or 43
Front Brake Antilock Sensor Y/GN 4

RH BL/GN 25
Rear Brake Antilock Sensor O 49

LH W/BL 45
Rear Brake Antilock Sensor PK/BL 44

- Are the resistances less than 5 ohms?

YES -- Go to E3. E3 Check Short Between Brake Control Module and Brake Sensors

NO -- Service the wire(s) in question.