E3 Check Short Between Brake Control Module and Brake Sensors

- Key OFF.

- Disconnect the brake antilock sensor connectors.

- Connect the breakout box with adapter to the antilock brake control module connector. Leave the antilock brake control module disconnected.

- Measure the resistance of the following wires between the following BOB Pins and ground.

BOB Pin Wire Color

16 W

56 GN

9 or 43 Y/BL

4 Y/GN

25 BL/GN and LG

49 O

45 W/BL

44 PK/BL

- Are the resistances greater than 10,000 ohms?

YES -- Replace the brake antilock sensor(s) in question.

NO -- Service the wire(s) in question between the antilock brake control module and the brake antilock sensor.