Keyless Entry Transmitter: Service and Repair

NOTE: The remote entry features will not function when the ignition switch is in the RUN or ACC position.

The keyless entry remote transmitters:
^ Are reprogrammable.
^ Must be set at the same time.

To unlock the driver door, memory seat position 1 or 2 (if equipped with memory seats), disarm the anti-theft system:
^ Press the UNLOCK button on the keyless entry remote transmitter.

NOTE: If more than five seconds have elapsed since the first press of the UNLOCK button, pressing the UNLOCK button again will only unlock the driver door a second time.

To unlock all doors:
^ Press the UNLOCK button on the keyless entry remote transmitter a second time, within five seconds of the first unlock.

To lock all doors and arm the anti-theft system:
^ Press the LOCK button on the keyless entry remote transmitter once.

To confirm that the doors have been locked and that the anti-theft system has armed:
^ Press the LOCK button again, within five seconds of the first press. The horn will chirp once if the doors have locked and all doors are closed. The horn will chirp twice if a door is open, indicating that the anti-theft system will not arm until the door is closed.

To activate the panic alarm:
^ Press the red PANIC button on the keyless entry remote transmitter. The horn will sound and the headlamps and exterior lamps will flash for a maximum of two minutes and 45 seconds.

To deactivate the panic alarm:
^ Press the red PANIC button again on the keyless entry remote transmitter.
^ Turn the ignition switch to RUN/ACC.

Programming

NOTE: All keyless entry remote transmitters must be set at the same time

To program (or reprogram) the keyless entry remote transmitters into the RAP module, perform the these steps:

1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition switch from OFF to RUN five times within ten seconds, ending in RUN. If the RAP module has successfully entered program mode, it will lock and then unlock all doors.
3. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
4. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Diagnosis and Testing. Testing and Inspection
5. Turn the ignition switch to the OFF position, or wait up to five minutes after step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.