Hook-Up

PROCEDURE

New Generation STAR (NGS) Tester
1. Key OFF.
2. Verify that the proper memory (EPROM) card is inserted in the NGS.
3. Connect OBD II Data Link Connector (DLC) cable or Villager DLC cable to the NGS.
4. Connect OBD II DLC cable securely into the OBD II DLC, for generic diagnostics or the fuse panel DLC cable for expanded diagnostics.
5. Connect the NGS power supply cable to vehicle.
6. Turn key to ON or start vehicle if necessary. The NGS is ready to communicate with vehicle computers.
7. Follow instructions on the NGS screen display.
8. To disconnect tool, turn key to OFF and disconnect NGS from the appropriate DLC and power supply.

Generic Scan Tool (GST)
Refer to the manufacturer's manual for specific cables and/or adapters required for scan tool hookup.