Instrument Panel Finish Panel - LH

REMOVAL
1. Disconnect the battery ground cable.
2. Apply the parking brake to prevent the vehicle from moving.







3. Turn the ignition switch to the ACCESSORY position.
4. Shift the gearshift lever to first gear.
5. Tilt the steering wheel to the lowest position.
6. Grasp the rear window wiper/washer switch and using a rocking motion, remove the rear window wiper/washer switch. Disconnect the rear window wiper/washer electrical connector.
7. Grasp the heated back window switch and light and using a rocking motion, remove the heated back window switch and light if equipped. Disconnect the back window switch and light electrical connector.
8. Grasp the hazard warning flasher switch and using a rocking motion, remove the hazard warning flasher switch. Disconnect the hazard warning flasher switch electrical connector.
9. Grasp the security lamp indicator and using a rocking motion, remove the security lamp indicator, if equipped. Disconnect the security lamp indicator electrical connector.
10. Grasp the speed control actuator switch and using a rocking motion, remove the speed control actuator switch. Disconnect the speed control actuator switch electrical connector.
11. Grasp the headlamp switch and using a rocking motion, remove the headlamp switch. Disconnect the two headlamp switch electrical connectors.







12. Remove the two LH instrument panel finish panel screws.
13. Remove the fuel computer control panel, if equipped.
14. Remove the LH instrument panel finish panel.

INSTALLATION
1. To install, reverse the removal procedure.