Quick Test 2.0 - Set Up

Connect the New Generation STAR (NGS) Tester 418-FO48 (007-00600) or equivalent to Data Link Connector (DLC).

VEHICLE AND TESTER PREPARATION





The vehicle is equipped with two data link connectors, the OBD II connector is under the left side instrument panel directly below the steering column. The interior fuse junction panel DLC is located inside the interior fuse junction panel opening. Depending on which Data Link Connector (DLC) the New Generation STAR (NGS) tester is connected to, determines what data can be retrieved or functions performed. Please refer to the table.

Prepare to run OBD II procedures.
- Gearshift lever in Park (P).
- Engine at operating temperature.
- Apply parking brake.
- Block wheels.
- Turn ignition switch to the OFF position.
- Verify that the proper program card is inserted in the NGS Tester.
- Connect J1962/16 way DCL cable adapter to the NGS Tester.
- Connect NGS DCL cable adapter securely into the vehicle's data link connector.
- Turn the ignition switch to the ON position or start vehicle if necessary.

NOTE: If the NGS Tester does not communicate with the PCM, refer to Powertrain Management.

The NGS Tester is ready to communicate with the PCM.