Initial Inspection and Diagnostic Overview

WARNING: A vehicle equipped with a Traction-Lok(R) differential will always have both wheels driving. If, while the vehicle is being serviced, only one wheel is raised off the floor and rear axle is driven by the engine, the wheel on the floor could drive the vehicle off the stand or jack. Be sure both rear wheels are off the floor.

WARNING: Never run the engine with one wheel off the ground, for example, when changing a tire. The wheel(s) resting on the ground could cause the vehicle to move.

WARNING: Do not balance the wheels and tires while they are mounted on the vehicle. Possible tire disintegration or differential failure could result, causing personal injury and extensive component damage. Use off-vehicle wheel and tire balance only.

Be sure to follow the warnings when performing inspection and verification.

Road Test
Verify the customer concern by performing a road test on a smooth road. If any vibrations are apparent, go to refer to Vehicle Noise, Vibration and Harshness Diagnosis.
To maximize tire performance, inspect for signs of incorrect inflation and uneven wear, which may indicate a need for balancing, rotation, or front suspension alignment.
Correct tire pressure and driving techniques have an important influence on tire life. Heavy cornering, excessively rapid acceleration and unnecessary sharp braking increase tire wear.

Replacement tires must follow the recommended:
^ tire sizes.
^ speed rating.
^ load range.
^ tire construction type.

Use of any other tire size or type can seriously affect:
^ ride.
^ handling.
^ speedometer/odometer calibration.
^ vehicle ground clearance.
^ tire clearance between the body and chassis.
^ wheel bearing life.
^ brake cooling.

Wheels need to be installed new when:
^ bent.
^ cracked.
^ dented.
^ heavily rusted.
^ leaking.
^ they have elongated wheel hub bolt holes.
^ they have excessive lateral or radial runout.

Wheel and tire assemblies are attached by five centering lug nuts.
It is mandatory to use only the tire sizes recommended on the tire chart attached to the vehicle, affect durability, and require changing the speedometer calibration. Make sure wheel size and offsets match those recommended for the tire in use.
1. Inspect for signs of uneven wear that may indicate a need for balancing, rotation, front suspension alignment, damaged tie-rod, or steering components.
2. Check tires for:
^ cuts.
^ stone bruise.
^ abrasions.
^ blisters.
^ embedded objects.

3. Tread wear indicators are molded into the bottom of the tread grooves. Install a new tire when the indicator bands become visible.