Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts

D - Ring Installation Kit:

Special Tool(s)

1. Remove the B-pillar, C-pillar, or upper corner trim panel.







2. Use the half-inch drill provided in the D-Ring Installation Kit or equivalent to drill out the damaged threads.
3. Apply a suitable lubricant to the M14x1.5 tap provided in D-Ring Installation Kit or equivalent and tap new threads.

NOTE: After each rotation, back the tap off slightly to remove new cuttings and be sure to clean out any chips before proceeding.







4. Use a threaded insert provided in the D-Ring Installation Kit or equivalent and screw it into the retapped hole until it is slightly below the surface of the hole.







5. Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to drive down the insert keys.

NOTE: If the height adjuster bolts are stripped, replace the height adjuster.