Ignition Cable: Service and Repair

Spark Plug Wire Remover:

SPECIAL SERVICE TOOL(S)

REMOVAL

CAUTION: Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wire locations before removing them.

NOTE: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.







1. Use the special tool with a twisting motion to pull the spark plug wire off the spark plug.







2. Squeeze the locking tabs and twist while pulling upward to disconnect the spark plug wires from the ignition coil.







3. Remove the spark plug wires from the retaining brackets and remove the spark plug wires.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE:
^ Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.
^ Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171A to the inside of spark plug and ignition coil boots of the spark plug wire.