Speaker Walk-Around Test and T100i DM Self-Diagnostic Mode

The T1OOi DM self-diagnostic mode tests can only be entered while in the Speaker Walk-Around Test.

NOTE: The audio unit must be turned ON and in radio tuner mode (AM/FM) to enter the Speaker Walk-Around Test or the T100i DM self-diagnostic mode.

1. To enter the Speaker Walk-Around Test, press Preset Buttons 3 and 6 simultaneously, hold for approximately three seconds and then release.
2. The Speaker Walk-Around Test stops at each speaker and applies tone to each speaker for approximately 1 - 2 seconds. Each speaker is tested and shown on the display in the following sequence: SPEAKER RF, SPEAKER LF, SPEAKER LR, SPEAKER RR, ANTENNA, SUBWOOFER 1.
3. The Speaker Walk-Around Test automatically continues and tests if the CD/DJ is present and responding. NO CD/DJ is displayed if the CD/DJ is not present or not responding.
4. To exit Speaker Walk-Around Test turn the ignition key OFF or turn the audio unit OFF.
5. The T1OOi DM self-diagnostic mode has five manual tests available:
^ Preset button 1 = Audio internal/external SELF TEST. This test is an on-demand self-test. If diagnostic trouble codes (DTCs) are retrieved, press TUNE > to scroll view the DTCs stored. Refer to the T100i DM Diagnostic Trouble Code (DTC) Index. If system is OK, NO DTCS is displayed. Diagnostic Trouble Code Tests and Associated Procedures
^ Preset button 2 = View/Clear continuous DTCS (historical DTCS) (early production). On late production, preset button 2 will have no self-test function. NO DTCS is displayed if no DTCs are retrieved. Press TUNE > button to view if any DTCs are stored. Refer to the T1OOi DM Diagnostic Trouble Code (DTC) Index. To clear all DTCs press the EJ (eject) button. DTCS CLEAR is displayed. Diagnostic Trouble Code Tests and Associated Procedures
^ Preset button 3 = SIGNAL TEST. This test measures the average strength at the current tuner setting.

NOTE: Always DOCUMENT, CLEAR, and CARRY OUT the T1OOi DM On-Demand Self-Test again.

^ Preset button 4 = Software configuration level. This test queries each radio system controller for their software configuration level. SOFT LEVELS will be displayed upon completion of the query.
^ Preset button 5 = DISPLAY TEST. This test will light all the T100i DM display segments for 5 seconds then turn all segments OFF. When the test is complete DISPLAY TEST is displayed on the bezel.
6. To enter these tests, press the preset button desired while in the Speaker Walk-Around Test or still in the T100i DM self-diagnostic mode.
7. To exit the T1OOi DM self-diagnostic mode, turn the ignition switch OFF or the T100i DM OFF.
8. If the concern remains and the fault is not detected, proceed to Symptom Chart to continue diagnostics. Symptom Related Diagnostic Procedures