Cruise Control Module: Service and Repair
REMOVAL1. Disconnect the battery ground cable.
2. Remove the front seats.
3. Remove the right and left side scuff plates.
NOTE: Left side shown, right side similar.
4. Remove the right and left side A-pillar lower trim panels.
NOTE: Left side shown, right side similar.
5. Remove the console cover.
1 Remove the four pin-type retainers.
2 Remove the console cover.
6. Remove the side kick panels.
1 Remove the nut.
2 Remove the screws.
3 Remove the side kick panels.
NOTE: Left side shown, right side similar.
7. Remove the accelerator stopper cover.
1 Remove the accelerator stopper screw.
2 Remove the accelerator stopper cover.
8. Position aside the floor carpet.
1 Remove the rear seat air flow duct bolts.
2 Remove the rear seat air flow ducts.
3 Position aside the front floor carpet.
9. Remove the heat duct cover.
1 Remove the ten bolts.
2 Remove the heat duct cover.
10. Remove the rear seat right duct.
^ Remove the screws.
11. Remove the rear seat air flow outlet duct.
1 Remove the screws.
2 Remove the rear seat air flow outlet duct.
12. Remove the speed control module.
1 Remove the bolts.
2 Disconnect the speed control actuator module electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.