Customer Safety Information

WARNING: Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water to induce vomiting. Get medical attention immediately.

CAUTION: Install a new pad if worn to or past the specified thickness above the metal backing plate. Install new pads in complete axle sets.

CAUTION: Do not allow the brake caliper to hang by the flexible brake hose.

CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the brake pads.

CAUTION: Use a hub-mount brake lathe, if necessary, to machine the rear brake disc.

Clean the slipper mating surface. Apply 0.03g of Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4 to the slipper mating surface. Install the new slippers.


CAUTION: Install new brake pads in full axle sets. Do not install new brake pads on only one side of vehicle.