Steps 51-74

51. Install the engine splash shield.
52. Install the crankshaft pulley.





53. Install the spark plugs.





54. Install the water bypass hose.
1 Position the water bypass hose.
2 Position the clamp.





55. Connect the PCV breather hose and tube to the valve cover.
1 Connect the PCV breather hose and tube to the valve cover.
2 Install the bolt.
3 Position the clamp.





56. Connect the A/C compressor electrical connectors.
1 Position the wire harness.
2 Connect the A/C high pressure switch electrical connector.
3 Connect the A/C compressor clutch electrical connector.





57. Align the mark on the distributor shaft with the protruding mark on the distributor housing.





58. Install the distributor assembly.
1 Install the distributor.
2 Connect the electrical connector.
3 Connect and clip the electrical connector.
4 Install the bolt.





59. Confirm that the distributor rotor head is set as shown.





60. Install the distributor cap.
1 Position the distributor cap and spark plug wires.
2 Tighten the distributor cap screws.





61. Connect the heater hose to the heater hose pipe.
1 Connect the heater hose to the heater hose pipe.
2 Position the clamp.





62. Connect the coolant bypass hose to the water hose connection.
1 Connect the coolant bypass hose to the water hose connection.
2 Position the clamp.





63. Install the upper timing belt cover bolt.





64. Connect the upper radiator hose.
1 Connect the upper radiator hose.
2 Position the clamp.
3 Install the bolt.





65. CAUTION: Make sure the fuel injection supply manifold insulators are installed with the fuel injection supply manifold.

Install the fuel injection supply manifold and insulators.
1 Position the fuel injection supply manifold and insulators.
2 Install the bolts.





66. Connect the fuel lines.
1 Position the fuel line.
2 Install the bolts.
3 Connect the fuel hose.
4 Install the clamp.





67. Install the spark plug wire bracket bolt.
1 Position the spark plug wire bracket.
2 Install the bolt.





68. Connect the water temperature indicator sender unit electrical connector.





69. Position the PCV breather tube and wire harness.
1 Position the breather tube and wire harness.
2 Connect the PCV breather hose.
3 Position the clamp.
4 Install new wire straps.





70. Connect the H02S electrical connector.
1 Clip the wire harness to the bracket.
2 Connect the H02S electrical connector.





71. Install the ground wire bolts.





72. Connect the electrical connectors.
1 Connect the fuel injector electrical connectors.
2 Connect the ECT sensor electrical connector.
73. Install the upper intake manifold.
74. Check the ignition timing.