Reverse Servo Assembly

Reverse Servo Assembly

NOTE: Inspect the reverse servo piston seal for damage. If damaged, a new piston and seal assembly will need to be installed.

1. Disassemble the components in the order indicated in the illustration and table.





2. To assemble, reverse the disassembly procedure.

Item 4: Reverse Servo Plate Disassembly Note





1. WARNING: The upper and lower servo covers are under spring tension. Use care when separating the two halves. Failure to follow these instructions may result in personal injury.

NOTE: Tabs on servo plate mate with slots on cover every 120 degrees.

Remove the reverse servo plate by turning in either direction to release.
^ Align the arrow on the servo plate with any slot on the cover

Item 7: Reverse Servo Piston O-Ring Assembly Note





1. NOTE: Try not to roll the seal onto the housing when installing the seal or damage to the seal can occur.

Lubricate and install a new reverse servo piston seal.

Item 4: Reverse Servo Plate Assembly Note





1. WARNING: The upper and lower servo covers are under spring tension. Use care when separating the two halves. Failure to follow these instructions may result in personal injury.

CAUTION: The arrow on the servo plate must be aligned evenly between any two slots on the cover.

Install the reverse servo plate.