Removal and Installation
Exhaust System1. With the vehicle in NEUTRAL, position on a hoist.
2. If removing the converter assembly, remove the transmission crossmember.
3. Remove the components in the order indicated. To remove individual components, only carry out the listed steps.
Part 1 Of 2:
Part 2 Of 2:
4. To install, reverse the removal procedure.
5. Check and, if necessary, align the exhaust system.
Item 12: Converter Assembly Removal Note
1. If removing the converter assembly, the transmission crossmember must be removed.
2. Use a suitable jack stand to support the converter assembly.
Item 13: Catalyst Monitor Sensor Removal Note
1. If installing a new converter, remove the catalyst monitor sensors.
Item 14: Heated Oxygen Sensor Removal Note
1. If installing a new converter, remove the heated oxygen sensors.
Item 14: Heated Oxygen Sensor Installation Note
1. Make sure to apply anti-seize to the threads of the sensors before installation.
Item 13: Catalyst Monitor Sensor Installation Note
1. Make sure to apply anti-seize to the threads of the sensors before installation.
Item 7: Muffler Installation Note
1. Make sure that the tab on the muffler outlet pipe is seated inside the notch on the extension pipe before tightening the exhaust clamp.
Item 3: Extension Pipe Installation Note
1. Make sure that the tab on the muffler outlet pipe is seated inside the notch on the extension pipe before tightening the exhaust clamp.