Torque Specifications

Torque Specifications















CAUTION: Cylinder head bolts must be discarded and new bolts installed. They are tighten-to-yield designed and cannot be reused. REFER TO THE PROCEDURE IN THIS SECTION.


Crankshaft Pulley bolt:
Stage 1 45 Nm (33 ft. lbs.)
Stage 2 additional 85 degrees.





Flex Plate or Flywheel bolts.
Stage 1 13 Nm (10 inch lbs.)
Stage 2 71 Nm (52 ft. lbs.)

Exhaust Manifold nuts 22 Nm (16 ft. lbs.)

Water Pump bolts 10 Nm (89 inch lbs.)

Intake Manifold bolts 10 Nm (89 inch lbs.)





Camshaft bearing caps bolts.
Stage 1 6 Nm (53 inch lbs.)
Stage 2 16 Nm (12 ft. lbs.)

Jackshaft bolts 11 Nm (8 ft. lbs.)

Main Bearing Cap Torque and Sequence
For tightening specifications refer to Service and Repair procedure. Service and Repair

Rod Bearing Cap Torque
For tightening specifications refer to Service and Repair procedure. Service and Repair