40 Percent of 60/40 Bench, Second Row
REAR SEAT BACKREST - 40 PERCENT OF 60/40 BENCH, SECOND ROWDISASSEMBLY
1. Remove the second row, 40 percent seat.
2. Remove the second row, 40 percent seat backrest.
Part 1:
Part 2:
3. Disassemble the components in the order listed in the illustration and table.
Item 3: Latch Trim Cover Screws Disassembly Note
1. Remove the three screws (two shown) and the latch cover.
Item 8: Head Restraint Sleeves Disassembly Note
1. NOTE:
- The inboard and outboard head restraint sleeves are not interchangeable.
- The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
Item 9: Backrest Trim Cover Disassembly Note
1. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat backrest foam pad.
Separate the hook and loop fasteners. Remove the seat backrest trim cover.
Item 16: Latch Assembly Disassembly Note
1. CAUTION: Do not detach the latch cable from the seat latches. The latch assembly is synchronized; if disassembled, the latch assembly may not operate correctly.
Do not separate or disassemble the latch assembly components.
ASSEMBLY
1. To assemble, reverse the disassembly procedure.