Monitors, Trips, Drive Cycles and Readiness Codes

Transmission Drive Cycle Test

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Drive Cycle Test must be followed exactly. Transmission failure must occur four times consecutively for shift error DTC code to be set, and five times consecutively for continuous torque converter clutch code to set.

NOTE: When carrying out the Transmission Drive Cycle Test, use the Solenoid Operation Chart for proper solenoid operation. Refer to Pinpoint Tests - OSC Equipped Vehicles. Diagnostic Trouble Code Tests and Associated Procedures

After carrying out the Quick Test, use the Transmission Drive Cycle Test for checking continuous codes.
1. Record and then erase Quick Test codes.
2. Warm engine to normal operating temperature.
3. Make sure transmission fluid level is correct.
4. With transmission in (D) position, moderately accelerate from stop to 80 km/h (50 mph). This allows the transmission to shift into fifth gear. Hold speed and throttle open steady for a minimum of 15 seconds.
5. With transmission in fifth gear and maintaining steady speed and throttle opening, lightly apply and release brake to operate stop lamps. Then hold speed and throttle steady for a minimum of five seconds.
6. Brake to a stop and remain stopped for A minimum of 20 seconds.
7. Repeat steps 4 through 6 at least five times.
8. Carry out Quick Test and record continuous DTCs.