Fog/Driving Lamp: Service and Repair

FOG LAMP

REMOVAL

NOTE: Make sure the headlamp switch and ignition switch are in the OFF position.

1. Remove the front wheel and tire.

















2. Remove the parts in the order indicated in the illustration and table.

To remove individual parts, only carry out the listed steps.


Item 5: Adjusting Screw Removal Note
1. The fog lamp adjusting screw does not need to be removed. It is pivoted downward to release the fog lamp housing.

Item 7: Fog Lamp Bulb Removal Note

WARNING: The halogen bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.

1. The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed from the housing.


INSTALLATION
1. To install, reverse the removal procedure.