Stabilizer Bar: Service and Repair

Stabilizer Bar and Link - Front

NOTE: Use the hex holding feature to prevent the studs from turning while removing or installing the stabilizer bar link nuts.

1. With the vehicle in NEUTRAL, position on a hoist.

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

2. Remove the parts in the order indicated in the following illustration and table.
3. To install, reverse the removal procedure.

Item 3: Stabilizer Bar Links Inspection Note
1. Inspect the stabilizer bar link ball Joints and boots for wear. If necessary, install new parts.

Item 4: Subframe Bolt Removal Note
1. Remove and discard the subframe bolts.
2. Lower the rear of the subframe 5 to 8 cm (2 to 3 inch) to gain access to the stabilizer bar bracket retaining bolts.

Item 8: Stabilizer Bar Bushing Inspection Note
1. Inspect the stabilizer bar bushings for wear. If necessary, install new parts.

Item 4: Subframe Bolt Installation Note

1. CAUTION: Do not use power tools to install the subframe bolts.

Install new subframe bolts using hand tools.