Bench Seat, Second Row
REAR SEAT CUSHION - BENCH SEAT, SECOND ROWDISASSEMBLY
1. Seat with optional cupholder shown, without cupholder similar.
2. Remove the bench seat, second row.
Part 1:
Part 2:
3. Disassemble the parts in the order listed in the illustration and table.
To remove individual parts, only carry out the listed steps.
Item 1: Recliner Handle Clip Disassembly Note
1. Using a suitable tool, carefully pry the side shield for access to the recliner handle clip and remove the clip.
Item 3: Pivot Handle Clip Disassembly Note
1. Access the pivot handle clip from the bottom side of side shield, and remove the clip.
Item 17: Backrest-to-Cushion Bolt Disassembly Note
1. Removal of cushion release cables.
1 Release the RH cable end.
2 Release the RH cable from the anchor retainer.
3 Release the LH cable end.
4 Release the LH cable from the anchor retainer.
Item 36: Seat Cushion Trim Cover Disassembly Note
1. Release the J-clips.
2. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat cushion foam pad.
Separate the hook and loop fasteners.
3. Remove and discard all the hog rings (one shown) and remove the cushion trim cover.
ASSEMBLY
1. To assemble, reverse the disassembly procedure.