Third Row
REAR SEAT CUSHION - THIRD ROWDISASSEMBLY
1. Remove the third row seat.
2. Open the third row seat to normal sitting position.
Part 1:
Part 2:
3. Disassemble the parts in the order listed in the illustration and table.
To remove individual parts, only carry out the listed steps.
Item 7: Backrest-to-Cushion Nuts Disassembly Note
1. Remove the four (two shown) backrest-to-cushion nuts.
2. Backrest-to-cushion removal.
1 Release the hook-and-loop fastener and remove fabric flap.
2 Release the center J-clips.
3 Pull the center material down and route the material behind the tether anchor bar and remove the seat backrest.
Item 10: Cushion Trim Cover Disassembly Note
1. Remove the screws and pin-type retainers, and remove the latch covers (one shown).
2. Release the J-clips.
3. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat backrest foam pad.
Separate the hook-and-loop fasteners.
4. Remove and discard all the hog rings and remove the cushion trim cover.
Item 16: Cushion Latch Cables Disassembly Note
1. Release the cables and route handle through seat pan.
2. Release the cable from seat pan clips (one shown).
ASSEMBLY
1. To assemble, reverse the disassembly procedure.