Electronic Engine Controls

ELECTRONIC ENGINE CONTROLS

The electronic engine controls consist of the following:
- powertrain control module (PCM)
- camshaft position (CMP) sensor
- crankshaft position (CKP) sensor
- mass air flow (MAF) sensor
- heated oxygen sensor (HO2S)
- knock sensor (KS)
- catalyst monitor sensor
- cylinder head temperature (CHT) sensor

The PCM carries out the following functions:
- accepts input from various engine sensors to compute the fuel flow rate necessary to maintain a prescribed air/fuel ratio throughout the entire engine operational range.
- outputs a command to the fuel injectors to meter the appropriate quantity of fuel.

The CMP sensor:
- sends the PCM a signal indicating camshaft position used for fuel synchronization.

The CKP sensor:
- sends the PCM a signal indicating crankshaft position.
- is essential for calculating spark timing.

The MAF sensor:
- uses a hot wire sensing element to measure the amount of air entering the engine. Air passing over the hot wire causes it to cool.

The HO2S:
- creates a voltage signal dependent on exhaust oxygen content.
- provides feedback information to the PCM used to calculate fuel delivery.

The catalyst monitor sensor:
- monitors oxygen content after it flows through the catalytic converter.
- provides a voltage to the PCM used to calculate catalytic converter integrity.

The KS:
- is used to detect engine detonation.
- sends a voltage signal to the PCM.
- is able to provide a signal which retards the ignition timing, as necessary.

The CHT:
- is mounted to the wall of the cylinder head and is not connected to any coolant passages.
- sends a signal to the PCM indicating the cylinder head temperature.
- If the temperature exceeds approximately 121°C (250°F), the PCM disables half of the fuel injectors at a time. The PCM will alternate which fuel injectors are disabled every 32 engine cycles. The cylinders that are not being fuel injected act as air pumps to aid in cooling the engine.
- If the temperature exceeds approximately 166°C (330°F), the PCM disables all of the fuel injectors until the engine temperature drops below approximately 154°C (310°F).
- The coolant temperature gauge pointer will read fully hot.
- The check gauge warning indicator will illuminate and the DTCs are set.