Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR

Special Tool(s):

SPECIAL TOOL(S)

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the drive belt.

Part 1:

Part 2:

3. Remove the parts in the order indicated in the illustration and table.

Item 1: Power Steering Pump Pulley Removal Note







1. Using the special tool, remove the power steering pump pulley.

Item 2: Power Steering Pump Stud Bolts Removal Note







1. Remove the nuts and position the wiring harness bracket and the ground wire aside.

Item 3: Power Steering Pump Bolt Removal Note







1. Remove the support bracket.







2. Disconnect the power steering high pressure tube. Remove and discard the O-ring seal.

Item 4: Power Steering Pump Removal Note
1. Position the power steering pump aside.

Item 5: Power Steering Reservoir Bracket Nut Removal Note







1. Remove the nut and position the radio interference capacitor aside.

Item 6: Power Steering Reservoir Bracket Removal Note
1. Position the power steering reservoir and bracket assembly aside.

INSTALLATION
1. To install, reverse the removal procedure.

Item 5: Power Steering Reservoir Bracket Nut Installation Note







1. Install the radio interference capacitor.

Item 3: Power Steering Pump Bolt Installation Note







1. Using the special tool, install a new O-ring seal on the power steering high pressure tube.







2. Connect the high pressure power steering tube.







3. Install the support bracket.

Item 2: Power Steering Pump Stud Bolts Installation Note







1. Install the ground wire and the wiring harness bracket.

Item 1: Power Steering Pump Pulley Installation Note







1. Using the special tool, install the power steering pump pulley.