Fog/Driving Lamp: Service and Repair

FOG LAMP

Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 4 front fender splash shield bolts.
- To install, tighten to 5 Nm (44 lb-in).

3. Remove the 4 front fender splash shield pin-type retainers.
- Position the front fender splash shield aside.

4. Disconnect the fog lamp bulb electrical connector.
5. Remove the 4 fog lamp screws and the fog lamp.
6. To install, reverse the removal procedure.