Condenser to Evaporator Line

CONDENSER TO EVAPORATOR LINE







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the air conditioning (A/C) refrigerant.
3. Remove the front bumper cover.
4. Disconnect the high pressure cut-off switch electrical connector.
5. Remove the condenser to evaporator line bracket nut.
- To install, tighten to 8 Nm (71 lb-in).

6. Disconnect the evaporator core spring lock coupling.
7. Remove the condenser to evaporator line peanut fitting nut and disconnect the line.
- To install, tighten to 8 Nm (71 lb-in).

8. Remove the condenser to evaporator line.

9. NOTE: New O-ring seals lubricated with clean mineral oil must be installed before connecting any A/C fitting which has been disconnected.

To install, reverse the removal procedure.
- Evacuate, leak test, and charge the refrigerant system.