Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)







Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the 2 powertrain control module (PCM) stud bolt nuts and position the wiring harness and the manifold absolute pressure sensor aside.
- To install, tighten to 9 Nm (80 lb-in).

3. Disconnect the 3 PCM electrical connectors.
4. Remove the stud bolts and the PCM.
- To install, tighten to 9 Nm (80 lb-in).

5. Remove the PCM cowl seal.
6. To install, reverse the removal procedure.