Wheel Speed Sensor-Front

Wheel Speed Sensor-Front





Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.

2. NOTE: The harness connector is located in the engine compartment.

Disconnect the electrical connector.
3. Using a suitable tool, remove the grommet.
4. Remove the front wheel speed sensor wire from the retainer.
5. Remove the 2 front wheel speed sensor wire bolts.
^ To install, tighten to 9 Nm (80 inch lbs.).
6. Remove the front wheel speed sensor bolt from the wheel knuckle.
^ To install, tighten to 9 Nm (80 inch lbs.).

7. NOTE: Clean off any debris that may have collected around the sensor before removal.

Remove the front wheel speed sensor.

8. NOTE: Thoroughly clean the mounting surface.

To install, reverse the removal procedure.