Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor





Material

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.





2. Remove the 7 retainers and the LH splash shield.
^ To install, tighten to 10 Nm (89 inch lbs.).





3. Remove the Output Shaft Speed (OSS) sensor.
1 Disconnect the OSS electrical connector.
2 Remove the OSS sensor bolt.
3 Remove the OSS sensor.
^ To install, tighten to 13 Nm (10 ft. lbs.).





4. NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.

Inspect the O-ring seal for nicks or cuts. Install a new O-ring seal as necessary.
5. To install, reverse the removal procedure.