Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor





Material

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.





2. Remove the 7 retainers and the LH splash shield.
^ To install, tighten to 10 Nm (89 inch lbs.).





3. Remove the turbine shaft speed (TSS) sensor.
1. Disconnect the TSS electrical connector.
2. Remove the TSS sensor bolt.
3. Remove the TSS sensor.
^ To install, tighten to 13 Nm (10 ft. lbs.).





4. NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.

Inspect the O-ring seal for nicks or cuts. Install a new O-ring seal as necessary.
5. To install, reverse the removal procedure.