Rear Seat Backrest - Bucket Seat, Second Row
REAR SEAT BACKREST - BUCKET SEAT, SECOND ROWRemoval and Installation
NOTE: LH seat shown, RH seat similar.
1. Remove the second row bucket seat.
2. Remove the fold and tumble knob.
3. Remove the front and rear LH side shield screws.
4. Using a suitable tool, carefully pry the LH side shield for access to the recliner handle clip and remove the clip and the LH recliner handle.
5. Remove the remaining 2 screws and the LH side shield.
6. Remove the 2 screws and the RH side shield.
7. Remove the bolt and the safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).
8. Disconnect the cushion release cables.
1 Release the cable from the anchor retainer.
2 Unclip the cable end.
9. Remove the 3 backrest-to-seat track bolts and remove the backrest from the seat cushion.
- To install, tighten to 45 Nm (33 lb-ft).
10. To install, reverse the removal procedure.