Inspection and Verification
INSPECTION AND VERIFICATIONWARNING:
- When using a remote starter switch or jumper wire, be sure the ignition switch is in the OFF position and the transmission is in PARK with the parking brake control fully applied.
- When servicing starter motor or carrying out other underhood work in the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter solenoid is "electrically hot" at all times. A protective cap or boot is provided over this terminal that must be installed after servicing. Be sure to disconnect the battery negative cable before servicing the starter. Failure to follow these instructions can result in personal injury.
- When working in the area of the starter motor, be careful to avoid touching hot exhaust components.
NOTE: When working on the starter system, make sure the anti-theft system is operational.
1. Verify the customer concern by operating the starting system to duplicate the conditions.
Visual Inspection Chart:
2. Inspect to determine if any of the mechanical or electrical concerns apply.
3. If the inspection reveals an obvious concern that can be readily identified, repair it as necessary.
4. If the concern remains after the inspection, determine the symptom. GO to Symptom Chart. Symptom Related Diagnostic Procedures