Front Seat

FRONT SEAT







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- LH seat shown, RH seat similar.

1. Position the seat to gain access to all 4 mounting bolts.
2. Depower the SRS.
3. Remove the front outboard seat track-to-floor bolt cover.
4. Remove the 2 front seat track-to-floor bolts.
- To install, tighten to 40 Nm (30 lb-ft).

5. Remove the 2 rear seat track-to-floor bolt covers.







6. Remove the 2 rear seat track-to-floor bolts.
- To install, tighten to 40 Nm (30 lb-ft).

7. NOTE: Some component connectors may not exist due to vehicle options.

Disconnect the seat electrical connectors.

8. Remove the seat.
9. To install, reverse the removal procedure.
10. Repower the SRS.
11. Check the active restraint system for correct operation.