Seat Track

SEAT TRACK

Seat Track (Part 1):

Seat Track (Part 2):

Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- LH seat shown, RH seat similar.

All seats







1. Position the front seat to gain access to all 4 mounting bolts and the safety belt buckle pretensioner bolts.
- If the safety belt buckle and pretensioner are to be removed, position the seat track so the safety belt buckle and pretensioner bracket is in the seat track opening.

2. Depower the SRS.
3. Remove the affected front seat.
4. Remove the front seat backrest.
5. Remove the safety belt buckle pretensioner cover (if equipped).

6. NOTE: The safety belt buckle pretensioner bolts must not be reused. New bolts that are included in the seat fastener service kit (78600A58) must be used.

Remove and discard the 2 safety belt buckle and pretensioner bolts. Separate the safety belt buckle and pretensioner from the seat track.
- To install, tighten to 40 Nm (30 lb-ft).

7. Remove the electrical cap cover, disconnect the safety belt pretensioner and buckle switch electrical connectors and remove the safety belt buckle pretensioner.
8. Release the seat cushion trim cover retainers from the seat cushion pan and remove the trim cover and foam pad.
9. Remove the seat cushion support.







10. Drive out the 2 recliner roll pins (one shown) at the cushion pan and discard them (for installation, use 2 new roll pins). Remove the recliner assembly.

Memory seats
11. Remove the screw, slide the driver seat module back and separate it from the bracket.

Disconnect the electrical connectors and remove the memory seat module.

12. Remove the 4 screws and the driver seat module bracket.

Driver seat
13. Remove the screw, disconnect the electrical connector and remove the seat track position sensor.

All vehicles
14. Detach the plastic retainer from the seat pan and bracket and remove the pretensioner wire harness.
15. Detach the plastic retainer from the seat pan and bracket and remove the seat wire harness.
16. To install, reverse the removal procedure.
17. Install the front seat backrest.
18. Install the affected front seat.
19. Repower the SRS.