Rear Seat - 20 Percent, Second Row
REAR SEAT - 20 PERCENT, SECOND ROWRemoval and Installation
1. Remove the rubber bolt caps.
2. Remove the 2 front riser-to-floor nuts.
- To install, tighten to 40 Nm (30 lb-ft).
3. Fold both of the 40 percent seats up to the E-Z entry position.
4. Remove the 2 riser-to-floor middle bolts (one shown).
- To install, tighten to 40 Nm (30 lb-ft).
5. Remove the 2 riser-to-floor rear bolts (one shown).
- To install, tighten to 55 Nm (41 lb-ft).
6. Remove the 20 percent seat from the vehicle.
7. To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.