Front / Wheel Bearing and Wheel Hub
Wheel Bearing and Wheel HubRemoval and Installation
1. NOTE: The wheel speed sensor electrical connectors are located in the engine compartment secured to the fender aprons.
Disconnect the wheel speed sensor.
2. Remove the wheel and tire assembly.
3. Detach the wheel speed sensor harness from the brake hose.
4. Remove the brake hose-to-wheel knuckle bolt.
^ To install, tighten to 15 Nm (11 ft. lbs.).
5. Remove the 2 anchor plate bolts.
^ To install, tighten to 112 Nm (83 ft. lbs.).
6. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.
Position the caliper, pads and anchor plate aside.
7. Remove the brake disc.
8. Remove and discard the 3 wheel hub-to-wheel knuckle bolts.
^ To install, tighten to 112 Nm (83 ft. lbs.).
9. Remove the wheel bearing and hub assembly.
10. To install, reverse the removal procedure.
^ Always install new wheel hub-to-wheel knuckle bolts.