Rear Seat Backrest - Third Row

REAR SEAT BACKREST - THIRD ROW







Disassembly and Assembly
1. Remove the third row seat backrest.
2. Remove the 2 head restraints.







3. Remove the load floor from the seat backrest.
1 Remove the 8 screws (4 shown) and the load floor.
2 Rotate the load floor rod 90 degrees and pull it out.
- Repeat for the load floor rod on the other side.

4. Release the backrest trim cover J-clip.







5. NOTE:
- The inboard and outboard head restraint sleeves are not interchangeable.
- The head restraint sleeves incorporate an alignment tab that must face forward when installed.

Lift the trim cover and foam pad out of the way, squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
- Repeat to remove the other head restraint sleeves.

6. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat backrest foam pad.

Separate the hook and loop fasteners and remove the backrest trim cover.

7. Remove the backrest foam pad.
8. Remove the 4 backrest latch bolts.
9. Separate the backrest release handle and cable from the backrest and remove the backrest pivot latch assembly.
10. Remove the load floor rod sleeves.
11. To assemble, reverse the disassembly procedure.