Rear Seat Backrest - 40 Percent of 60/40 Bench, Second Row

REAR SEAT BACKREST - 40 PERCENT OF 60/40 BENCH, SECOND ROW

Removal







1. Release the seat backrest J-clip.







2. Remove all the staples in the backrest support panel.







3. Invert the seat backrest trim cover and foam pad to access the latch cover screws.







4. Remove the 4 screws and the 2 covers (outboard shown, inboard similar). Detach the seat backrest material attachment from both of the latch covers.







5. Remove the 2 backrest pivot bolts (inboard side shown, outboard side similar).
6. Remove the 60 percent backrest.

Installation







1. Position the backrest to the latch. The cable is to be routed in front of the spring.







2. CAUTION: The cable is to move freely after assembly.

NOTE: When installing the backrest to the cushion, make sure the latch cover does not come in contact with the latch cable conduit or end fitting.

The cable is to pass between the backrest frame and the backrest support at the 2 points shown.







3. Install the 4 backrest pivot bolts (inboard side shown, outboard side similar).
- Tighten to 40 Nm (30 lb-ft).







4. CAUTION: When installing the backrest to the cushion, make sure the latch cover does not come in contact with the latch cable conduit or end fitting.

Position the 2 covers and install the 4 screws (outboard shown, inboard similar). Attach the material attachments to both of the latch covers.

5. Roll the seat backrest trim cover and foam pad back down into position.







6. Position the trim cover and install staples in the backrest support panel.
7. Attach the seat backrest J-clip.