Rear Seat - Third Row

REAR SEAT - THIRD ROW







Removal and Installation







1. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out.
2. Remove the 2 third row backrest-to-floor
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the 2 third row backrest-to-floor bolts.
- To install, tighten to 10 Nm (89 lb-in).

4. Fold the third row seat backrest down and remove the rear load floor panel.







5. Access the backrest to floor attachments.
1 Release the trim fabric hook and loop fasteners.
2 Remove the wheel jack storage cover.

6. Remove the jack assembly.
7. Remove the 2 outer load floor support panel bolts and the load floor support panel.
8. Remove the 2 third row backrest-to-floor outer bolts.
- To install, tighten to 10 Nm (89 lb-in).

9. Remove the 2 third row backrest-to-floor inner bolts.
- To install, tighten to 40 Nm (30 lb-ft).

10. Remove the third row backrest.
11. To install, reverse the removal procedure.
12. Check the active restraint system for correct operation.