Turn Signals: Service and Repair

Steering Column Multifunction Switch

Removal and Installation

CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.

1. Disconnect the battery.
2. Remove the 2 screws and the steering column lower shroud.





3. Remove the screw and the steering column upper shroud.
1 Release the 2 retaining clips and rotate the upper steering column trim panel out of the instrument panel.
2 Remove the upper steering column shroud.
4. Remove the multifunction switch screw.
5. Disconnect the 3 multifunction switch electrical connectors.
6. Remove the multifunction switch.
7. To install, reverse the removal procedure.