Stabilizer Link: Service and Repair

Stabilizer Bar Link

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.

2. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.

Remove the upper stabilizer bar link nut.
^ To install, tighten to 63 Nm (46 ft. lbs.).

3. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer link nut.

Remove the lower stabilizer bar link nut.
^ To install, tighten to 55 Nm (41 ft. lbs.).

4. NOTE: Inspect the stabilizer bar link ball Joints and boots for wear. If necessary, install new parts.

Remove the stabilizer bar link.
5. To install, reverse the removal procedure.