Removal and Installation

SPARK PLUGS







Exploded View

Removal
1. Disconnect the battery ground cable.
2. Disconnect the ignition coil electrical connectors.
3. Remove the bolts and the ignition coils.

4. NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.

Remove the spark plugs.

Installation







1. Inspect the spark plugs.







2. Adjust the spark plug gap as necessary.
3. Install the spark plugs.
- Tighten to 12 Nm (9 lb-ft).

4. NOTE: Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.

Install the ignition coils and bolts.
- Tighten to 10 Nm (89 lb-in).

5. Connect the ignition coil electrical connectors.
6. Connect the battery ground cable.