Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)







Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the powertrain control module (PCM) stud bolt nut and position the wiring harness aside.
- To install, tighten to 9 Nm (80 lb-in).

3. Disconnect the 3 PCM electrical connectors.
4. Remove the 2 stud bolts and the PCM.
- To install, tighten to 9 Nm (80 lb-in).

5. Remove the PCM cowl seal.
6. To install, reverse the removal procedure.